Starting from Build 2061, it displays wrongly! I can't select or edit them
ST seems to be treating each Chinese character as one character,
but actually every Chinese character equals to two English characters.
Can anyone help
Unable to read non-English characters
1 post • Page 1 of 1
Unable to read non-English characters
by cal623 on Wed Jun 08, 2011 1:04 pm
Sometimes I need to handle some Chinese characters in the file, and ST able to show them normally.
Starting from Build 2061, it displays wrongly! I can't select or edit them
ST seems to be treating each Chinese character as one character,
but actually every Chinese character equals to two English characters.
Can anyone help
Starting from Build 2061, it displays wrongly! I can't select or edit them
ST seems to be treating each Chinese character as one character,
but actually every Chinese character equals to two English characters.
Can anyone help
- cal623
- Posts: 6
- Joined: Thu Mar 31, 2011 3:08 pm
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 14 guests