Apologies: this is a duplicate of the following post:
but I have seenno response, and I think it may be because I did not mark the post as a “[BUG]”. Also, I do no tknow if it is possible to change the title of a post after the fact… so, again, apologies, and here goes:
I am experiencing the following behavior on both Mac and Windows with 2115: from the Terminal, if I invoke
subl “/Users/marciano/Documents/file.tex”
and then
subl “/Users/marciano/Documents/./file.tex”
I get two open tabs, pointing to the same file, but with a different file name (as verified by hovering). [Of course, on Windows, replace “/” with “”]
Furthermore, on Windows, if from the command line I invoke
sublime_text.exe “C:\Users\marciano\Documents\file.tex”:100
and then
sublime_text.exe “c:\Users\marciano\Documents\file.tex”:100
[with a lowercase drive letter “c:” instead of "C:] again I get two open tabs. However, if I omit the line number, this is not the case!
Is this behavior intended? On the Mac, TextMate always jumps to the correct file regardless of whether or not “/./” is added to the file name. Also, on Windows, TeXnicCenter does not care if the drive letter is upper or lower case.